|
|
|
| 9 Ft and 11 Ft Non-Shock Mounted Bay Frame Packs |
 |
|
 |
| Packing List: |
| Check to assure all parts are included before starting
assembly.
|
| Item |
Quantity |
Description |
| 1 |
1 |
Corrugated tray |
| 2 |
1
(2) |
Corrugated sleeve
(2 corrugated c-folds for wide packs) |
| 3 |
1 |
Short wood block with cutouts |
| 4 |
2 |
Long wood block with cutouts |
| 5 |
2 |
Center upright |
| 6 |
1 |
Cross brace |
| 7 |
1 |
Base assembly with straps |
| 8 |
2 |
End support assembly (shown setup on base at left) |
| 9 |
1 |
Hardware bag |
| 10 |
varies |
Desiccant pouches (if ordered) |
|
| Call us to advise of any damage, shortages or to request
additional assembly assistance.
|
|
|
| Packing Instructions for 9ft and 11ft Non-Shock Mounted Bay Frame Packs |
-
Lay the straps freely along the side of the base as shown. Place the 3/8" x 4
1/2" carriage bolts through the holes at the ends of the base.
-
Place each end support onto the bolts at the ends of the base. Note the
orientation as shown.
-
Position the bay frame horizontally (on it's side) on the base.
-
Secure the end supports to the base using 318" flat washer, lock washer and
nuts. Tighten securely.
-
Loosen the frame side locks on the end supports and butt tightly against the
frame. Tighten securely.
-
Loosen the top blocks on the end supports and butt tightly against the frame.
Tighten securely.
-
Use the bar nut and bolt in the vertical slot on the end supports to secure the
frame to the end support. Tighten securely.
-
Position the 4" x 12" plywood frame blocks and nail to the base with the #4
nails provided.
-
Nail the center uprights onto the side rails. Note the matching notches on the
uprights and rails.
-
On smaller packs slide the one-pieced sleeve over the pack to rest on the
runners. On larger packs bring the C-folds around the pack to rest on the
runners.
-
Place the wood blocks with cutouts on top of the frame. Note the location of
the short block. Nail through the center uprights into the ends of the short
block.
-
Nail the cross brace onto the center uprights as shown.
-
Using the squarehed nails provided, nail through the corrugated sleeve into the
side rails, end supports and the ends of the long wood blocks.
-
Place the top tray over the entire pack and secure by bringing the straps over
the top and threading them through the buckles. Use the cotter pins provided to
secure the straps.
|
|
|
|
|