|
|
|
| 7 FT. ESS Frames in Vertical Packs |
 |
|
|
|
 |
| Packing List: |
| Check to assure all parts are included before starting
assembly.
|
| Item |
Quantity |
Description |
| A |
1 |
Wood pallet with moveable clamping blocks and cargo straps |
| B |
1 |
Corrugated slotted tray |
| C |
2 |
Corrugated scored sheet - packed in separate bundle |
| D |
3 |
Dado trusses |
| E |
1 |
| Hardware bag consisting of the following: |
| (2) |
Hairpin cotters - used to secure buckles on straps from opening during shipment |
| (24) |
Squarehead nails |
| (2) |
Tipping Indicators |
| (2) |
Plywood blocks |
| (1) |
Set of assembly instructions |
|
| F |
1 |
Polyvinyl anti-static bag with humidity indicator (if ordered) |
| G |
varies |
Desiccant (if ordered) |
|
| Call us to advise of any damage, shortages or to request
additional assembly assistance.
|
|
|
| Packing Instructions for Installing 7' ESS Frames in
Vertical Packs |
-
Move cargo straps clear of deck.
-
Slide (2) moveable clamping blocks (part 3) to extreme outward position.
-
On each of the moveable clamping blocks, there are two width adjustment tangs.
Slide these to their extreme outward position.
-
Lower the frame onto approximate center of deck. If necessary, remove 4 lag
bolts and plywood end as shown and remove one moveable clamping block to allow
for easier installation of the frame.
-
Slide moveable clamping blocks inward to contact frame and tighten (4) bolts on
ends to secure, for details see dado
trusses/clamping block page.
-
Slide width adjustment tangs inward to contact frame and tighten (4) bolts to
secure. (On the 196V5 and l99VS there are two intermediate hold down blocks,
which must be rotated into position and secured by tightening one bolt in each
block.)
-
* Place desiccant bags at various locations on the unit, then place the
anti-static bag over the unit and over the side rails to contact the deck. Note
the polyethylene foam perimeter at the base of the side rails. Tape the
humidity indicator at a location where it is visible through the bag.
-
* Tightly wrap 1" wide strapping tape around the base of the bag, compressing
the foam to form a seal.
-
Place (2) corrugated scored sheets on the 4eck, up against the side rails, with
the printed panel of each sheet on the outside. Place one tipping indicator at
the center of one length panel and one width panel.
-
Secure the scored sheets around the base with squarehead nails.
-
Locate (3) dado trusses on top of the frame, one approximately centered, and
one at each end. Secure the scored sheets with squarehead nails into the ends
of the wooden blocks.
-
Put cap in place.
-
Secure cap with cargo straps. Refer to Cargo
Strap Buckling Instructions. * Disregard steps 7 and 8 when anti-static
bags and desiccant are not used.
|
|
|
|
|